Intel® D815EFV System Board Technical Reference

Features

    This PGA 370 system board uses the Intel® 82815E chipset. The system board supports:

SDRAM DIMM system memory
Intel Pentium ® III processor
(with 100 MHz and 133 MHz front side bus)
or Intel Celeron™ processor
(with 66 MHz and 100 MHz front side bus)
Ultra ATA 66/100 drives
Advanced Configuration and Power Management Interface (ACPI)
Integrated video with Intel 82815E Graphics and Memory Controller Hub
Integrated audio with Analog Devices codec

System board layout

    The following illustration shows the system board divided into two sections:

Section 1

    1. Front panel harness connector

    2. Intrusion detection switch connector

    3. BIOS configuration jumper block

    4. Front panel USB connector

    5. PCI expansion slots

    6. Telephony (modem) audio connector

    7. Communication Network Riser (CNR) expansion slot (reserved)

Section 2

    1. Diskette cable connector

    2. Primary IDE cable connector

    3. Secondary IDE cable connector

    4. CD In audio connector

    5. Aux In audio connector

    6. Front panel audio connector/configuration jumper (reserved)

    7. Power supply cable connector

    8. Auxiliary fan connector

    9. Battery

    10. Memory expansion slot (DIMM 2)

    11. Memory expansion slot (DIMM 1)

    12. Processor PGA 370 Zero Insertion Force (ZIF) socket

    13. Processor heat sink fan connector

    14. Personal System/2TM (PS/2) mouse port

    15. PS/2 keyboard port

    16. USB ports

    17. Monitor port

    18. LPT (printer) port

    19. COM 1 (serial) port

    20. LAN (network) jack

    21. USB ports (available on some configurations)

    22. Audio line out (speakers) jack

    23. Microphone line in jack

    24. Audio line in jack

BIOS configuration jumper settings

    The BIOS configuration jumper lets you clear passwords or recover your BIOS if it becomes corrupted. For information about the location of this jumper, see Section 1.

Setting Jumper placement When used

Normal

For normal operation. The BIOS uses current configuration information and passwords.

(1-2 position)

Configure

For clearing passwords. The BIOS Setup utility runs automatically and the Maintenance menu is displayed.

(2-3 position)

Recovery

For recovering the BIOS configuration. A BIOS recovery diskette is required.

(no jumper)

Specifications

    The following specifications are for the standard configuration. Your system may contain optional equipment. All specifications are subject to change without notice or obligation.

Supported processors

Intel Pentium® III processor
(with integrated 256 KB level two cache)

Intel Celeron™ processor
(with integrated 128 KB level two cache)

Chipset

Intel 82815E

Memory

3.3 V, 168-pin, 4-clock 133 MHz SDRAM DIMMs with gold-plated contacts.

Two Dual Inline Memory Module (DIMM) slots.

Support for up to 512 MB SDRAM
(using 128 Mbit-based DRAM).

Video subsystem

Intel 82815E Graphics and Memory Controller Hub
(integrated in the chipset)

Audio subsystem

Intel 82801BA I/O Controller Hub (ICH2)

Analog Devices codec

16-bit stereo, full-duplex operation at asynchronous hardware record/playback samples rates

Frequency response: 20 Hz to 20 kHz (± 0.1 dB)

LAN subsystem

Integrated Intel 82562ET 10/100 Mbit/sec LAN

BIOS

Intel/AMI BIOS. Flash BIOS for easy updates from diskette.

Hard drive interface

Supports up to four IDE devices using two on-board PCI IDE connectors. Automatic drive type selection for easy setup.

Diskette drive interface

A diskette drive controller is integrated on the system board. Support is available for a single diskette drive.

Input/Output connectors

One parallel port and one serial port. LPT and COM settings are configurable from the system setup program. No jumper changes required.

Universal Serial Bus (USB)

2 rear ports (2 additional rear ports available on some configurations)

Support for 2 front ports

Mouse

PS/2 mouse connector

Keyboard

PS/2 keyboard connector

Battery

2032-style

PCI expansion slots

3

Communication Network Riser (CNR) expansion slots

1 (reserved)

Environment

Operating temperature: 10°C to 35°C (50°F to 95°F)

Humidity: 20% to 80%

Altitude: -60.96 m to 3048 m

CPU clearance: >10.16 mm after installation, top and sides

    Many products for Gateway and its subsidiaries are custom engineered by our suppliers to Gateway specifications and may vary from similarly marketed products.