Regulatory Compliance Update

    The following information replaces the FCC declaration of conformity and European Union sections found in Appendix A of the Using Your Gateway PC guide that came with your computer.

FCC declaration of conformity

    Responsible party:

    Gateway Companies, Inc.
    610 Gateway Drive, North Sioux City, SD 57049
    (605) 232-2000   Fax: (605) 232-2023

    Product: (Where X, Y, or Z are any alpha numeric character or blank.)

GPX XXXXX
SELECT XXXXX
ESSENTIAL XXXXX
PERFORMANCE XXXXX
PROFESSIONAL X XXXXX
XXXXXXXX YYY 300ZZ
XXXXXXXX YYY 500ZZ
XXXXXXXX YYY 700ZZ

    For unique identification of the product configuration, please submit the 10-digit serial number found on the product to the responsible party.

    This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

European Union

    The following information is only applicable to systems labeled with the CE mark:

     

European directives

    This Information Technology Equipment has been tested and found to comply with the following European directives:

EMC Directive 89/336/EEC with amending directives 92/31/EEC & 93/68/EEC as per

    - EN 55022 Class B
    - EN 61000-3-2
    - EN 61000-3-3
    - EN 55024

Low Voltage Directive (Safety) 73/23/EEC as per EN 60950(A1/A2/A3/A4/A11)
Radio and Telecom Terminal Equipment Directive 199/5/EC as per CTR21 (if fitted with a modem device)

European telecommunication information (for products fitted with EU-approved modems)

    Marking by the CE mark symbol indicates compliance of this equipment to the Radio and Telecom Terminal Equipment Directive 1999/5/EC. Such marking is indicative that this equipment meets or exceeds the following technical standards:

    CTR 21 - Attachment requirements for pan-European approval for connection to the analogue Public Switched Telephone Networks (PSTNs) of TE (excluding TE supporting voice telephony services) in which network addressing, if provided, is by means of Dual Tone Multi-Frequency (DTMF) signaling.

    Warning

    Although this equipment can use either loop disconnect (Pulse) or DTMF (Tone) signaling, only the performance of the DTMF signaling is subject to regulatory requirements for correct operation. It is therefore strongly recommended that the equipment is set to use DTMF signaling for access to public or private emergency services. DTMF signaling also provides faster call setup.

      This equipment has been approved to Council Decision 98/482/EEC--"CTR 21" for Pan-European single terminal connection to the Public Switched Telephone Network (PSTN). However, due to differences between the individual PSTNs provided in different countries, the approval does not, of itself, give an unconditional assurance of successful operation on every PSTN termination point. In the event of problems, you should contact Gateway Technical Support.