||1570 W when operated between 170 VAC and 264 VAC
||78% minimum when operated under the maximum loading conditions of 90 VAC to 264 VAC and environmental conditions.
77% minimum when operated between 85 to 90 VAC.
|Input Over-Current Protection
||An internal normal blow (fast blow) high-breaking-capacity fuse is located in the input circuit.
||Initial surge or spike <10 ms not to exceed 55 A
Additional surges or spikes due to AC cyles or muliple AC cycles greater than 10 ms but less than 150 ms, not to exceed 25 A peak.
|Power Factor Correction
||0.97 or greater for all specified AC input voltages with output loads greater than 90%
0.75 or greater for all specified AC input voltages with output loads greater than 50%
|AC Input Connector
||IEC-320 16 A rated for 250 VAC minimum
|AC Input Rating
||See additional table at the bottom of this page
|DC Output Requirements
||+ 12 V:
- Minimum: 11.64 V
- Nominal: 12.00 V
- Maximum: 12.60 V
- Minimum: 3.17 V
- Nominal: 3.30 V
- Maximum: 3.47 V
||Hot swappable when two power supplies are used
Over- and under-voltage protection
Short circuit protection
Reset after shutdown
||Power good LED: Lights green whenever PWRGD is asserted.
Power supply fail LED: Lights amber when a power rail has failed.
AC OK LED: Lights green whenever VIN_GOOD is asserted.
|Dimensions (H × W × D)
||Approximately 3.5 × 7.7 × 14.5 inches