 |
|
Frequently Asked Questions
BIOS
 What are the beep codes for the Gateway 9510/E-9510T server motherboard?
Controller
Using the integrated LSI SCSI controller, can I create more than one mirror set?
Drives
My server shipped with a CD/DVD writer. What software is included with my server to utilize this drive?
General
Does the Gateway 9510/E-9510T Server support hotplug PCI?
I am receiving a message from my BIOS. What does it mean?
What is the correct order to update the FRU/SDR, BMC, HSC, and BIOS for the 9510?
I have installed the ROMB option with the battery backed cache. Why do I repeatedly see a message during POST that the battery is low?
What RAID levels are supported using the integrated U320 SCSI controller on the Gateway 9510 server?
What keystroke do I use to enter the integrated U320 SCSI controller utility?
How is a failure indicated on an array configured using the SATA embedded RAID controller?
Can I mirror multiple copies of a drive using the integrated U320 SCSI controller?
How do I configure a mirror using the RAID feature of the integrated U320 SCSI controller?
How can I verify that the drives are mirrored on the integrated U320 SCSI controller?
How do I recover from a failed drive in a mirror configuration on the integrated U320 SCSI controller?
My server BIOS allows me to select different SCSI modes. What do these modes do?
How can I view the System Event Log produced by the mBMC or BMC?
How can I clear the System Event Log?
When flashing the FRU/SDR, I am prompted for a password. What password do I use?
Is there a utility for the integrated U320 SCSI controller that can be used to detect RAID drive failures when no ROMB is installed?
How can I make my USB flash drive boot to MS-DOS in order to perform system firmware flashes?
Network
What do the LEDs on the integrated NIC indicate?
RAID
How do I rebuild a failed drive in an array configured using the integrated SATA RAID controller in the Gateway 9510 Server?
How long does it take to rebuild an array configured on the integrated SATA RAID controller?
What is the default rebuild rate set on the integrated SATA RAID controller?
How do I enter the Embedded SATA RAID BIOS?
Why am I not prompted to enter the SATA RAID BIOS?
How do I configure SATA RAID using the integrated SATA RAID controller?
How do I enter the LSI SCSI ROMB RAID BIOS during POST?
How long should it take to initialize a RAID array using the integrated U320 SCSI controller?
Technical
When looking at my drives, I see that there are two types of errors; a media error and another error. What do these indicate?
|
|
|
United States
(change country or region)