| Error Code |
Error Message |
Response |
| 0000 |
Timer Error |
Warning |
| 0004 |
CMOS Settings Wrong |
Warning |
| 0005 |
CMOS Settings Bad |
Warning |
| 0012 |
CMOS Date/Time Not Set |
Warning |
| 0040 |
Refresh timer test failed |
Halt |
| 0044 |
DMA Controller Error |
Halt |
| 0045 |
DMA-1 Error |
Halt |
| 0046 |
DMA-2 Error |
Halt |
| 0048 |
Password check failed |
Halt |
| 004C |
Keyboard/Interface Error |
Warning |
| 004D |
Primary Master Hard Disk Error |
Warning |
| 004E |
Primary Slave Hard Disk Error |
Warning |
| 0055 |
Primary Master Drive - ATAPI Incompatible |
Warning |
| 0056 |
Primary Slave Drive - ATAPI Incompatible |
Warning |
| 005D |
S.M.A.R.T. Status BAD, Backup and Replace |
Warning |
| 0120 |
Thermal Trip Failure |
Warning |
| 0146 |
Insufficient Memory to Shadow PCI ROM |
Pause |
| 0150 |
BSP Processor failed BIST |
Warning |
| 0160 |
Processor missing microcode - P0 |
Warning |
| 0161 |
Processor missing microcode - P1 |
Warning |
| 0180 |
BIOS does not support current stepping - P0 |
Pause |
| 0181 |
BIOS does not support current stepping - P1 |
Pause |
| 0192 |
L2 cache size mismatch |
Pause |
| 0193 |
CPUID, Processor stepping are different |
Pause |
| 0194 |
CPUID, Processor family are different |
Pause |
| 0195 |
Front side bus mismatch. System halted. |
Pause |
| 0196 |
CPUID, Processor Model are different |
Pause |
| 0197 |
Processor speeds mismatched |
Pause |
| 5120 |
CMOS Cleared By Jumper |
Warning |
| 5121 |
Password cleared by jumper |
Warning |
| 5122 |
CMOS Cleared By BMC Request |
Warning |
| 8103 |
Warning! Unsupported USB device found and disabled! |
Warning |
| 8104 |
Warning! Port 60h/64h emulation is not supported by this USB Host Controller! |
Warning |
| 8105 |
Warning! EHCI controller disabled. It requires 64-bit data support in the BIOS. |
Warning |
| 8110 |
Processor 1 Internal Error (IERR) |
Warning |
| 8111 |
Processor 2 Internal Error (IERR) |
Warning |
| 8120 |
Processor 1 Thermal Trip error |
Warning |
| 8121 |
Processor 2 Thermal Trip error |
Warning |
| 8130 |
Processor 1 disabled |
Warning |
| 8131 |
Processor 2 disabled |
Warning |
| 8140 |
Processor 1 failed FBR-3 timer |
Warning |
| 8141 |
Processor 2 failed FBR-3 timer |
Warning |
| 8150 |
Processor 1 failed initialization on last boot |
Warning |
| 8151 |
Processor 2 failed initialization on last boot |
Warning |
| 8160 |
Processor 1: unable to apply BIOS update |
Pause |
| 8161 |
Processor 2: unable to apply BIOS update |
Pause |
| 8170 |
Processor 1 failed BIST |
Warning |
| 8171 |
Processor 2 failed BIST |
Warning |
| 8180 |
BIOS does not support current stepping for Processor 1 |
Pause |
| 8181 |
BIOS does not support current stepping for Processor 2 |
Pause |
| 8190 |
Watchdog timer failed on last boot |
Warning |
| 8198 |
OS boot watchdog timer failure |
Warning |
| 8300 |
BaseBoard Management Controller Failed Self-Test |
Pause |
| 8301 |
Front Panel Controller failed to function |
Pause |
| 8305 |
Primary Hot Swap Controller failed to function |
Warning |
| 8306 |
Power Share Controller failed to function |
Warning |
| 84F1 |
BIST failed for all available processors |
Halt |
| 84F2 |
BaseBoard Management Controller failed to respond |
Pause |
| 84F3 |
BaseBoard Management Controller in Update Mode |
Pause |
| 84F4 |
Sensor Data Record Empty |
Pause |
| 84FF |
System Event Log Full |
Warning |
| 8500 |
Bad or missing memory in slot 4A |
Pause |
| 8501 |
Bad or missing memory in slot 3A |
Pause |
| 8502 |
Bad or missing memory in slot 2A |
Pause |
| 8503 |
Bad or missing memory in slot 1A |
Pause |
| 8504 |
Bad or missing memory in slot 4B |
Pause |
| 8505 |
Bad or missing memory in slot 3B |
Pause |
| 8506 |
Bad or missing memory in slot 2B |
Pause |
| 8507 |
Bad or missing memory in slot 1B |
Pause |
| 8601 |
All memory marked as fail. Forcing minimum back online. |
Pause |
United States
(change country or region)