Frequently Asked Questions
How do I disable the PXE Boot ROM on the 995 server?
Can I upgrade my SCSI BIOS for my integrated SCSI controller separately from my system BIOS?
How do I view the BIOS system event log on a 995 server?
How do I update the BIOS and firmware on the 995 Server?
What is the blue light on the front and back of the server for?
What does the verify media option do in the SCSI BIOS utility?
What is 48-bit LBA support and why do I need this for my server?
How can I tell what firmware revision my hard disk is currently using?
How do I utilize the Hot-Plug PCI features of the 995 server?
What can I do to remove the memory or CPU error message after the error has been resolved?
Why must I install four memory modules at a time when upgrading memory in my 995 server?
How much memory does the 995 server support?
What can I do when I receive ECC memory errors?
What amount of time drift is considered normal on the 955, 975 and 995 series servers?
What are the beep codes for the 995 Server?
Does an empty CPU socket require a terminator on the 995 motherboard?
What rules should I follow for proper PCI card placement in the 995 server?
Do regular PCI cards work in PCI-X card slots?
How do I configure my server for out of band management?
What are the wake up events for the the server to come out of a power management state?
Can I disable Hyper-Threading on this server?
Are additional voltage regulator modules (VRMs) required when adding more CPUs?
Why am I seeing twice the number of CPUs that the server actually has when I open Task Manager?
In what order do I populate CPUs on the CPU board in the 995 server?
How are the interrupts routed?
How does the 995 server implement Fault Resilient Booting?
What are the methods for restarting the server properly?