Frequently Asked Questions
      Show Part Numbers

      Show Model(s)

Q: What are the menu options for the 9715 Local Control Panel module?

A: The following table shows the menu options for the 9715 Local Control Panel (LCP) module.

Menu Options Description
Configure the Server Network (LAN channel 1 to 3)

  • IP address (BMC)
  • Netmask
  • Gateway address
  • Enable LAN channel
Configure TCO NIC
Inventory

  • CPUs
  • DIMMs
  • Drives
  • Power supplies
  • System fans
View system inventory
Server name View server name
Asset tag information View asset tag
Server GUID View server GUID
BIOS revision View BIOS revision
BMC firmware revision View BMC firmware revision
Local control panel firmware revision View LPC firmware revision
HSC firmware revision View HSC firmware revision
HSC2 firmware revision View HSC2 firmware revision
Monitor the Server POST progress codes View POST progress codes
Server health (drill down to subsystem(s) at fault) View the health of the system
System event log View the system event log
CPU sensors (CPU 1 to n)

  • Presence
  • Over temperature
  • On/off line
View CPU related status
Chassis status
Intrusion status
Power supply 1 to n

  • Presence
  • Status

Fan 1 to n

  • Presence
  • Status
  • Speed

HSC 1 to 2

  • Presence
  • Status
View chassis related status
Temperature (all available temperature sensors) View all available temperature sensor status
Control the Server Boot flags (select from available boot flags)

  • Set the flag - one time reboot
  • Reboot the system
Configure boot order
Power control

  • Power on
  • Power off (graceful or hard)
Control the power state by creating button pushes - as if performed on the front panel by the user.
Reset Power control
IPMI control

  • Power on
  • Power off (graceful or hard)
Send the chipset a power control command. The same functionality as if done over LAN or by GSM.
IPMI command screen

  • Issue an IPMI command (text or hex)
Issue an IPMI command
Set Up the Server Language selection (display loaded language files) Select the LCP display language
Status setup

  • Interval timing (set time to retrieve status)
  • Subsystem mask (mask off subsystems)
Set sensor refresh interval
Password setup

  • Password exists/does not exist
  • Create/change password
Password setup
Remote access rights

  • View (grant or deny)
  • Write (grant or deny)
  • Buttons (grant or deny)
Remote access control