Frequently Asked Questions

Q: How is the LCD PCB Removed?

A:
  1. Power down the system and unplug both power supply cords.
  2. Open the system.
  3. Disconnect all cables to the LCD Front Panel Controller PCB, noting where the cables are connected.
  4. Remove the six screws holding the LCD Front Panel Controller PCB to the chassis.
  5. Remove the LCD Front Panel Controller PCB.

    Item No.DescriptionQty
    63CABLE ASSEMBLY, Signal Controller - Route from LCD Front Panel Controller PCB (Item 67, JP4) to System Board (Item 87, JP 27)1
    64CABLE ASSEMBLY, From Power Supply Subsystem to LCD Front Panel Controller (Item 67, JP 2) to Floppy Drive (Item 125)1
    65CABLE ASSEMBLY, CCFL, LCD Panel (Female) - Route cable from Front Panel Controller PCB (Item 67) through chassis to LCD Display Assembly (Item 56) and connect to CCFL, Controller Drive (Male), Item 55REF
    66SCREW, 4-40 x 3/16-inch Phillips pan head zinc6
    67LCD FRONT PANEL CONTROLLER PCB1
    68STAND-OFF, Hex 4-40 x ¼-inch6
    69WASHER, No. 4 internal tooth locking6
    70SCREW, 4-40 x 3/16-inch Phillips pan head zinc6