Frequently Asked Questions
What is the difference between verbose and silent mode on my SCSI controller?
What does the error message "SCSI timeout" mean?
What is indicated by the SCSI error message: "Device not ready/Send Unit start command failed"?
What is the slot number for my SCSI disk controller when loading Novell NetWare?
What is the difference between 68-pin and 80-pin SCSI drives and what kind does my server support?
What are some general SCSI troubleshooting tips?
Should I attach my SCSI tape drive or CD-ROM drive to the same cable as my hard drive?
What is the largest size SCSI hard drive I can use in my server?
What steps can be taken if a SATA, SCSI or RAID adapter BIOS does not respond during startup?
Support for Int13 extensions is enabled on my SCSI controller. What does this do?
What are the SCSI cable/bus length limitations?
What does the verify media option do in the SCSI BIOS utility?
What is the effect when disabling the BIOS on my SATA, SCSI or RAID hard drive controller?
What are the advantages of faster RPMs in regard to hard drives?
Not all of my drive space is recognized. Where is the rest?
How can I tell what firmware revision my hard disk is currently using?
When should I use term power on my SCSI devices?
What are the optimal SCSI settings for the tape backup unit?
What basic troubleshooting steps can be taken if the server's SCSI hard drive is not detected or recognized?
What does the acronym or term SAF-TE mean?