Frequently Asked Questions
How do I disable the PXE Boot ROM on the 995 server?
Can I upgrade my SCSI BIOS for my integrated SCSI controller separately from my system BIOS?
How do I view the BIOS system event log on a 995 server?
How do I update the BIOS and firmware on the 995 Server?
Where are my COA label and serial number located?
What is the blue light on the front and back of the server for?
Can I divide my server's SCSI hotswap backplane into more than one SCSI channel?
How do I remove the top rear cover?
How do I remove the processor and memory cover?
How do I remove the top front cover?
How do I replace a fan?
How do I remove the memory board?
How do I remove the processor board?
How do I remove the hot swap fan cage?
How do I replace a power supply unit in the 995 server?
How do I remove a slot cover or replace a PCI card?
How do I replace the CD-ROM and floppy disk drive combination module?
How do I utilize the Hot-Plug PCI features of the 995 server?
What can I do to remove the memory or CPU error message after the error has been resolved?
Why must I install four memory modules at a time when upgrading memory in my 995 server?
How much memory does the 995 server support?
What can I do when I receive ECC memory errors?
What amount of time drift is considered normal on the 955, 975 and 995 series servers?
Does an empty CPU socket require a terminator on the 995 motherboard?
What rules should I follow for proper PCI card placement in the 995 server?
Do regular PCI cards work in PCI-X card slots?
Can I use one power cord to power all of the power supplies in the 995 server?
Can I disable Hyper-Threading on this server?
Are additional voltage regulator modules (VRMs) required when adding more CPUs?
Why am I seeing twice the number of CPUs that the server actually has when I open Task Manager?
In what order do I populate CPUs on the CPU board in the 995 server?
How does the server configure the SCSI IDs?
What does the acronym or term SAF-TE mean?