Frequently Asked Questions
What is the difference between Hardware RAID and Software RAID?
Can I divide my server's SCSI hotswap backplane into more than one SCSI channel?
Can I combine both of my server's backplanes into a single logical unit (bus)?
Can I change the SCSI IDs on my server's backplane?
What are the SCSI cable/bus length limitations?
Can or should I mix different speed drives (RPMs) in the same hardware raid array? Are there disadvantages to this?
What is JBOD?
What is the difference between SCA-1 and SCA-2?
Why might the rebuilding of a RAID drive fail?
Can I use drives of different SCSI technologies (U320, U160, U2, Fast) in the same RAID array?
Will this newer SCSI hard drive work in my older Gateway server?
Can I change the SCSI IDs on my hard drive?
Can I swap out all the drives in my RAID 5 array without reloading my operating system?
One of my RAID HDDs failed. Should I remove it from the computer or leave it installed until it is replaced?
What is the ESG-HSV or GEM, and why is it being detected?
What is RAID 7?
What basic troubleshooting steps can be taken if the server's SCSI hard drive is not detected or recognized?
What does the acronym or term SAF-TE mean?
What is SCA-2?