| General |
|---|
| Processors | Up to two Intel Pentium III Coppermine or Tualitin processors operating at 1 GHz or faster |
| Cache | 256K or 512K, processor dependant |
| RAM | Four DIMM sockets support up to 4.0 GB of PC/133 SDRAM |
| BIOS | Phoenix flash BIOS for easy updates from disk |
| IDE interface | Two PCI controllers support as many as two ATAPI/IDE devices each (hard disks or CD-ROM drives) for a total of as many as four IDE devices (The chassis supports only the optional IDE CD-ROM drive.) |
| Disk drive interface | The disk drive controller is integrated on the motherboard. The chassis supports one slim-line floppy disk drive. |
| I/O ports | One serial port
One USB port on front panel
One PS/2 keyboard port
One PS/2 mouse port
Two RJ-45 network ports
One VGA video port |
| Power supply | 200-W power supply |
| SCSI interfaces | Integrated Adaptec AIC 7892 SCSI controller |
| Video chip set | ATI Rage XL AGP providing integrated SVGA video support with 4 MB of RAM |
| Network interface | Two Intel 82559 PCI Ethernet controllers |
| Server management | Monitoring, alerting, and logging of critical system information obtained from embedded sensors on the motherboard, including thermal levels, voltage levels, fan speeds, and chassis intrusion monitoring |
| Expansion slots | Two 64-bit, 66-MHz PCI slots on the riser card. |
| Drive bays | One CD-ROM drive bay (CD-ROM drive optional)
One floppy disk drive bay
Three hot-plug (at least one is occupied by a 1-inch high hot-plug drive) |
| Mechanical |
|---|
| 1U chassis case size | 1.67 × 16.73 × 24.5 inches (H × W × D) |
| Weight | 26.6 lbs |
| Environmental |
|---|
Temperature
Non-operating
Operating | Maximum rate of change = 10° C per hour
–20.0 to 60.0° C (–4 to 140° F)
0 to 40° (32 to 104° F)
derated 0.5° for every 1,000 feet (305 m) |
Humidity
Non-operating
Operating wet bulb | 95% relative (non-condensing) at 30° C (86° F)
5 to 85%, not to exceed 33° C (91.4° F)
(with floppy disk drive or hard disk) |
Shock
Operating
Packaged | 10.0 g, 11 ms, 1/2 sine
Operational after 30-inch free fall (cosmetic damage may occur) |
Vibration
Operating
Non-operating |
0.0032 g2/Hz 5 – 200 Hz, -6dB/octave 200 – 500 Hz
0.015 g2/Hz 5 – 200 Hz, -6dB/octave 200 – 500 Hz |
Altitude
Operating
Non-operating |
10,000 feet maximum
50,000 feet maximum |
| Heat dissipation | 422 BTU (loaded)
988 BTU (maximum) |
| Electrical |
|---|
AC input power
115 V –
230 V – |
90 – 135 V –, 3.2 A
180 – 265 V –, 1.6 A |
AC input frequency
115 V –
230 V – |
47 – 63 Hz
47 – 63 Hz |
| Total power | 86.562 W (loaded) |
The BTU maximum rating was derived by taking the maximum wattage output of the power supply, which is 202.9 watss (W), dividing it by the lowest efficiency of the power supply, which is 70 percent or 0.70, and multiplying by the BTU conversion number of 3.41. These numbers are rated at the worst case or lowest efficiency of the power supply. Under nominal conditions, the power supply should perform above the 70 percent efficiency level, which lowers the BTU rating.
United States
(change country or region)