| Feature |
Specification |
| Processors Supported |
Intel® Celeron® D
Intel Pentium® 4
Intel Pentium D |
| Front Side Bus (FSB) Speeds |
533 MHz (Celeron D)
800 MHz (Pentium) |
| Processor Features (When Supported by CPU) |
XD (eXecute Disable) bit
EM64T (64-bit) support
EIST (Intel Speed Step) support
HT (HyperThreading) support
VT (Virtualization) support (requires additional software support)
Dual Core support |
| Level 1 (L1) Cache |
16 KB |
| Level 2 (L2) Cache |
256 KB (Celeron D 3xx series)
1 MB (Pentium 4 5xx series)
2 MB (Pentium 4 6xx series)
2 × 1MB (Pentium D 8xx series) |
| Chipset |
Intel 945G with ICH7
8 MB Firmware Hub (FWH)
System clock
- 533 MHz (133 MHz × 4)
- 800 MHz (200 MHz × 4)
- 1067 MHz (267 MHz × 4; requires 1067 CPU)
|
| Memory |
400 MHz, 533 MHz, or 667 MHz dual-channel DDR2 SDRAM
Four 240-pin memory slots
Memory module capacities:
- 128 MB non-ECC
- 256 MB non-ECC
- 512 MB non-ECC
- 1024 MB non-ECC
Minimum memory:
- 128 MB, single channel mode
- 256 MB, dual channel mode
Maximum memory: 4096 MB (4 × 1024 MB)
Note: Microsoft® Windows® may not correctly report 4 GB of system memory. |
| Network |
Broadcom 5752 GbE PCIe controller with integrated Trusted Platform Module (TPM) 1.2 |
| Graphics |
Integrated Intel Graphics Media Accelerator 950
- 1.6 GP/s pixel rate
- 400 MHz core clock
- 4 pixel pipes
Shared video memory
*Video memory is dynamically allocated
- 224 MB (when 512 MB system memory present)
- 128 MB (when less than 512 MB system memory present)
- 10.6 GB/s maximum memory bandwidth
Max resolution: QXGA 75 Hz (2048 × 1536)
Other features
- DirectX 9
- Open GL 1.4 with vertex buffer and EXT_shadow
- Hardware Motion Comp (HWMC) MPEG2 decode
- Bob/weave De-interlacing
|
| Audio |
Integrated Intel High Definition Audio
- Sigmatel STAC9220 audio codec
|
Expansion Slots
(Half Height Cards Only) |
Two PCI conventional slots
One PCI-Express ×1 slot
One PCI-Express ×16 slot |
| Drive Bays |
One 5.25-inch external
One 3.5-inch external
One 3.5-inch internal (hard drive) |
| External Ports |
One serial
One parallel
One VGA monitor
One RJ-45 network
One PS/2 keyboard
One PS/2 mouse
Six USB 2.0 (four on rear-panel, two on front)
Three rear audio jacks
- Side surround left and right / line in / retasking jack
- Line out / retasking jack
- Microphone in / retasking jack
Two front audio jacks for headphone and microphone |
| Internal (Motherboard) Connectors |
Serial ATA
- Four 7-pin SATA connectors
- Supports up to 3 Gb/s
Primary IDE drive
- 40-pin connector on PCI local bus
- Supports up to two IDE Devices
34-pin floppy disk drive connector
Fan headers
- Rear chassis fan (4-pin)
- Front chassis fan (4-pin)
- CPU fan (4-pin, not used)
Internal USB
- Two USB headers
- Two ports per header
Chassis intrusion header |
| Power Supply |
305 or 400 watt
Voltage 110 / 220V |
| Case Dimensions (H × W × D) |
16.4 × 4.1 × 14.4 inches |
| Weight (Unpackaged) |
25 lbs (varies with configuration) |
| Temperature |
Operating: +5° C to +35° C (41° F to 95° F)
Non-operating: -20° C to +60° C (-4° F to 140° F)
Storage: -20° C to +60° C (-4° F to 140° F) |
| Humidity |
Operating: Wet bulb method, not to exceed 33° C (91.4° F)
Non-operating: 95% relative, non-condensing at 30° C (86° F) |
| Maximum Vibration |
Operating: 0.2g, 5Hz - 300 Hz
Non-operating: 0.5g, 5Hz - 300 Hz |
| Maximum Shock |
Operating: 0.5 g, 11 ms, ½ sine
Non-operating: 40 g, 11 ms, ½ sine |
| Operating Altitude |
10,000 ft max; maximum temperature is derated 0.5° C for every 305 m (1000 ft) above sea level |