Frequently Asked Questions
      Show Part Numbers

      Show Model(s)

Q: How do I remove and replace an add-in card in the 6-bay micro uBTX case?

A: Remove an add-in card

  1. Turn off the computer, and then disconnect the power cord.

  2. Remove the right side panel.

  3. Inside the case, the add-in card slots are located in the lower rear corner.

  4. At the rear of the case, flip the add-in card retention latch away from the case.
    View Picture
    View Picture

  5. For more stability, you can carefully lay the computer case on its left side.

  6. Inside the case, if applicable, disconnect any cables from the add-in card.

  7. Pulling at both ends of the card in a rocking motion, lift the card from the slot.

Replace an add-in card

  1. Align the card in the slot, and then press down firmly at both ends of the card to seat it in the slot.

  2. If applicable, connect cables to the card.

  3. Secure the card in the case by closing the add-in card retention latch.

  4. If needed, stand the computer case upright.

  5. Replace the right side panel.

  6. Connect the power cord, and then turn on the computer.