IBM PCI Token-Ring Driver Installation in Windows NT 3.51
      Show Part Numbers

  1. On your desktop, double-click the Main group icon. In Main, double-click the Control Panel icon. In Control Pnael, double-click the Networks icon. The Network installer will start. Select Yes when prompted to install networking components.
    View Picture

  2. Enter the path for the Windows NT CD or the location on the hard disk where the I386 directory is located.
    View Picture

  3. When prompted for whether or not Windows NT should detect the network card, select Do Not Detect.
    View Picture

  4. Setup will say that it did not detect a network card, click Continue to pick the network card manually.
    View Picture

  5. When the Add Network Adapter dialog box appears, select Other, Requires disk from manufacturer. Click Continue.
    View Picture

  6. Network Setup will prompt for the manufacturer's disk. Insert Disk 2 into the floppy disk drive. Enter the path: A:\Nt. Click OK.
    View Picture

  7. Under the Select OEM Option dialog box, select the IBM PCI Token-Ring adapter, and click OK.
    View Picture

  8. Choose the proper setting for the network card. Click Advanced. The default listings for the card are shown in the hyperlinked graphics. These will be blank, and must be filled-in manually. Click OK when complete.
    View Picture

    Advanced Settings
    View Picture

  9. Select the protocols used to connect to the network, if TCP/IP is chosen, the following dialog box appears. Click Continue when finished.
    View Picture

  10. The Network Setting dialog box appears, click Configure for the network settings, or click Bindings for advanced options.
    View Picture

  11. If IPX/SPX was selected, the following configuration screen appears for the Novell protocol. Click OK when done.
    View Picture

  12. Enter either a Workgroup or Domain Name and click OK.
    View Picture

  13. Windows NT will prompt to restart the computer, the installation is complete.