Frequently Asked Questions
      Show Part Numbers

Q: How do I add or replace memory modules in this notebook?

A: This notebook uses DDR2 RAM Small Outline Dual Inline Memory Modules (SO-DIMMs) memory modules. Two 200-pin industry standard DDR2-SODIMM sockets are located in this bay. The modules are available in various capacities. There is not a Slot 1/Slot 2 designation for the modules. Any module may be used in any available slot.
Use only memory modules designed for your Gateway® notebook when upgrading your memory.

Warning: Disconnect the notebook from the optional port replicator. Disconnect the power adapter, disconnect the modem and network cables, and remove the batteries before removing the memory bay cover. Replace the cover before restoring power or reconnecting the modem and network cables.

Note: Before beginning, review electrostatic discharge (ESD) precautions.

Adding or Replacing Memory Modules

  1. Turn off the notebook.

  2. Close the LCD panel.

  3. Disconnect all peripheral devices. Remove any ExpressCards or memory cards.

  4. Disconnect the AC adapter, modem cable, and network cable.

  5. Turn the notebook over so the bottom is facing up.

  6. Remove the battery.

  7. Loosen the five memory bay cover screws (these screws cannot be removed).
    Loosen the memory bay cover screws.

  8. Carefully so as to not break the tabs at the opposite end, use the thumb notch to lift the bay cover and remove it.
    Remove the hard drive bay cover.

  9. To remove a module:

    1. Gently press outward on the clip at each end of the memory module until the module tilts upward.
      Press outward on the clip at each end of the memory module until the module tilts upward.
    2. Pull the memory module out of the slot.
      Pull the memory module out of the slot.

    3. To remove a second module, repeat steps a. and b.

  10. To insert a new or replacement module:

    1. Hold the module at a 30-degree angle and press it into the empty memory slot. This module is keyed so that it can only be inserted in one direction. If the module does not fit, verify that the notch in the module lines up with the tab in the memory bay.
      Hold the module at a 30-degree angle and press it into the empty memory slot.
    2. Gently push down on the SO-DIMM and make sure that the two clips on each side of the SO–DIMM click into place.
      Gently push down on the SO-DIMM until it clicks into place.

  11. Slide the tabs located on the memory bay cover, into the slots on the bay, and then tighten the cover screws.
    Replace the memory bay cover.

  12. Insert the battery.

  13. Connect the AC adapter, modem and network cables, and then turn on the computer.