Specifications
Part Number: 4006188RECS 945GCT-M3 Motherboard

Following are the specifications for the ECS 945G-M3 motherboard.
Specifications are subject to change without notice or obligation.

Feature Specification
Form Factor
  • ATX (244 × 244 mm)
  • Four Layer printed circuit board (PCB)
  • Processor Support
  • Intel® Prescott, Tejas, and Conroe processors
  • Core Speed/Host Bus Speed 533 MT/s or 800 MT/s
  • LGA775 pins socket
  • Chipset
  • Intel Northbridge: NG82945GC
  • Intel Southbridge: FW82801GB
  • Other Chipsets
  • LPC ITE8712
  • Azalia Audio CODEC (ALC883)
  • LAN Realtek 8100C (10/100 M LAN)
  • Memory Support Two DIMM slots support the following:
    • DRAM Type 1.8V DIMM DDR DRAM configurations
    • Two 64-bit DDR data channels
    • Slot type: 1.8V un-buffered 240 pins DDR2 DIMM socket
    • Supports DDR2 400/533 MHz modules
    • Supports maximum memory bandwidth of 10.7 GB/s in dual-channel interleaved mode
    • Supports 256 Mb/512 Mb/1 GB DDR technologies for x8 and x16 non-ECC DDR devices
    • Registered DIMMs not supported
    • Maximum memory size 2 GB
    Bus Architecture
  • One PCI Express ×16 slot
  • One PCI Express ×1 slot
  • Two PCI conventional slots
  • Integrated REALTEK RTL8100C LAN
  • RTC and Battery
  • Intel FW82801GB Includes 256 Bytes CMOS SRAM
  • With CMOS SRAM hardware clear jumper
  • Peripheral Connectors
  • One "Ultra DMA/100/66/33" IDE
  • Four Serial ATA
  • One floppy disk drive
  • One Bi-directional/EPP/ECP printer
  • One IRDA infrared interface
  • Eight USB connections (four rear panel ports, four internal connections)
  • Two IEEE 1394 (one rear panel port, one internal connection)
  • CPU Regulator
  • On-Board Switching Power Controller - Support "VRD 10.1" Voltage Identification Codes
  • Voltage from 0.8375 V ~ 1.6 V in 12.5 mv steps