Motherboard Specifications
      Show Part Numbers

Following are the specifications for the ATI Xpress 200 (RC410) motherboard.
Specifications are subject to change without notice or obligation.

Feature Specification
Form Factor
  • Micro BTX
  • Dimensions: 10.5 × 10.4 inches
  • Chipset
  • MCH (Northbridge): ATI RC410 Rev. A13
  • ICH (Southbridge): ATI SB450 Rev. A13
  • Processor (CPU) Support
  • Intel® Pentium® 4, Pentium D, or Celeron® D processor
      Front Side Bus:
    • 533 MHz (Celeron D)
    • 800 MHz (Pentium 4 or Pentium D)
  • Processor features (when supported by CPU):
    • eXecute Disable (XD) bit
    • EM64T (64-bit support) support
    • Intel Speed Step (EIST) support
    • Hyper-Threading (HT) support
    • Virtualization (VT) support (requires additional software support)
    • Dual Core support
  • Memory Support
  • Two DDR2 DIMM slots
  • Accept DDR2 533/667 MHz single channel modules
  • Expandable up to 2 GB
  • Firmware Hub 4 MB LPC Flash ROM
    Network Support Integrated 10/100/1000 Realtek RTL8110S
    Integrated Audio
  • Interface: Azalia 5.1 channels
  • Model: Realtek ALC861
  • Serial Input/Output (SIO) Winbond 83627 EHF
    Add-in Card Slots
  • One PCI Express ×16 (graphics interface)
  • One PCI Express ×1
  • Two PCI conventional
  • Rear panel I/O Ports
  • Four USB 2.0 ports
  • Two PS/2 ports (keyboard and mouse)
  • One parallel port
  • One serial port
  • One VGA monitor port
  • One RJ-45 LAN port
  • Three analog audio jacks
  • Internal Headers
  • Two 2-port USB 2.0 headers (2 × 5)
  • Front panel audio header (2 × 5, mic / headphone)
  • Front panel header (2 × 5)
  • Chassis power LED header (1 × 3)
  • Floppy disk drive connector
  • Primary IDE connector
  • Secondary IDE connector
  • Four Serial ATA connectors
  • Two ATAPI headers
  • Clear CMOS jumper
  • Main Power Connector 24-pin (2 × 12)
  • Auxiliary 12V CPU power connector 4-pin (2 × 2)
  • CPU Fan 4-pin connector
  • Rear fan 4-pin connector