 |
|
Intel (El Paso) Motherboard - 1.5-GHz
Part Number:
2515372Intel (El Paso) Motherboard - 1.5-GHz
 |
This is the Intel® (El Paso) motherboard - 1.5-GHz. On the graphic or in the table at the bottom of this page, click the links for more information.
Features include:
- Intel® 82845 chipset consisting of:
- Intel® 82845 Memory Controller Hub (MCH)
- Intel® 82801BA I/O Controller Hub (ICH2)
- Intel® 82802AB BIOS Firmware Hub (FWH)
- Support for up to 1.5 gigabytes (GB) of memory using PC133 DIMMs
- AGP connector supporting 1.5-volt (V) 4X AGP cards
- Ultra DMA, ATA-33/66/100 support
- 100-megahertz (MHz) front bus speed (speed of motherboard)
- 400-MHz host bus speed (speed at which the I/O controller hub communicates with the processor)
- Advanced Configuration and Power Interface (ACPI) support (Power Management support)
- PCI local bus specification revision 2.2
- Integrated Audio and 10/100 Ethernet
|
Notes:
- Before adding, removing, or reseating any hardware, verify that the computer is unplugged. Then, either wait 30 seconds or press the power button to discharge the motherboard. The motherboard maintains power even after the computer is turned off.
- The individual part number for this motherboard is 4000742. This number helps locate the motherboard in Siebel. Some invoices list the motherboard separately and not as part of the sub-assembly, which includes the motherboard and processor. You cannot use the individual part number to replace this motherboard. Use the sub-assembly number at the top of this page.
- If Quick Boot is enabled in the BIOS Setup Utility, the monitor does not warm up soon enough to show the power-on self-test (POST) screen. Turn on the monitor, then the computer and press the F1 key immediately to enter the BIOS.
|
|
|
United States
(change country or region)