Network Driver Installation - Restoration CD 15.0 to 16.7

  1. Copy the necessary network files from the CD to the root directory of the hard disk. The path on the CD is Netcard\E1600.

  2. Click Start, point to Settings, and then click Control Panel. In Control Panel, double-click the Network icon. In the Network Configuration dialog box, click Yes to install Windows NT Networking.
    View Picture

  3. The Network Setup Wizard starts.
    View Picture

  4. Select the Wired to the network check box, and then click Next.
    View Picture

  5. Click Select from list.
    View Picture

  6. In the Select Network Adapter dialog box, click Have Disk.
    View Picture

  7. In the Insert Disk dialog box, type: c:\E1600 (assuming that this is the folder where the drivers were located after you copied them to the hard disk). Click OK.
    View Picture

  8. In the Network Setup Wizard dialog box, click Next.
    View Picture

  9. Select the appropriate network protocol check boxes, and then click Next.

    Note: TCP/IP is the most common, but others might be necessary according to your specific needs.
    View Picture

  10. The network services that are to be installed are listed. Click Next.
    View Picture

  11. Windows NT is ready to install the networking components. Click Next.
    View Picture

  12. Insert the Windows NT CD into the CD-ROM drive. In the Windows NT Setup dialog box, verify that the directory is correct, and then click Continue.
    View Picture

  13. If necessary, re-insert the original media into the drive. In the Setup Message dialog box, click OK.
    View Picture

  14. In the Network Setup Wizard dialog box, click Next.
    View Picture

  15. Windows NT continues installing the software.
    View Picture

  16. In the Microsoft TCP/IP Properties dialog box, on the IP Address tab, in the Adapter text box, type the IP address or click Obtain an IP address from a DHCP server. This step depends on your computer's configuration. You must know this configuration or get the information from the network administrator.
    View Picture

  17. Click the DNS tab, and then type the domain name system (DNS) information.
    View Picture

  18. Click the WINS Address tab, and then type the appropriate information.
    View Picture

  19. Click the Routing tab, and then select the Enable IP Forwarding check box, if necessary. Click OK.
    View Picture

  20. You can now check the bindings for:

    • All services
    • All protocols
    • All adapters

    and confirm that these settings are correct.

  21. In the Network Setup Wizard dialog box, click Next.
    View Picture

  22. Type the computer name. Click Workgroup or Domain, and then specify which workgroup or domain. If you click Domain, you can also select the Create a Computer Account in the Domain check box to create an account for the computer on the domain. If the computer is replacing another computer on the domain, this is not necessary.

  23. In the Create a Computer Account in DOMAIN Domain dialog box, type the user name and password of the person doing the installation. This person must have administrative rights to create accounts. Click OK.
    View Picture

  24. In the Network Setup Wizard dialog box, click Finish to conclude the installation.
    View Picture

  25. In the Network Settings Change dialog box, click Yes to restart the computer.
    View Picture

  26. To view the properties of the network interface card (NIC), in Control Panel, double-click the Network icon.

  27. In the Network dialog box, click the Adapters tab.
    View Picture

  28. On the Adapters tab, double-click Intel[R] PRO/100 VE Network Connection to view the properties.