Specifications
Part number 7001243

Destination 36-inch Monitor Specifications
CRT Invar shadow mask type 38-inch diagonal CRT with a viewable size of 35.5 inches.
Neck size: 32.5 mm
Diagonal deflection angle: 110°.
Maximum Resolution 800 × 600
Display Colors Unlimited
Horizontal Stripe Pitch Screen center: 0.9 mm
Screen edge: 1.1 mm

Note: The variance between the screen center and screen edge stripe pitch may make the monitor look comparatively fuzzy at the edge. This is not a defect.
Scanning Frequency Horizontal, 31 to 38 kHz; Vertical, 60 to 72 Hz
Aspect Ratio 4:3
Video Bandwidth 40 MHz nominal
Input Signal Video Sync Analog: 0.07 Vpp 75 Ohm
Separate sync: TTL level
Horizontal sync: positive/negative
Vertical sync: positive/negative
Power Input 90 to 264 VAC, 50 to 60 Hz ±3 Hz
Dimensions
( W x H x D)		 880 × 790 × 650 mm
Approximately 34.65 × 31.1 × 25.6 inches
Weight 99 kg (218 lbs)
Power Management Meets Energy Star requirements and conforms to the VESA Power Management Protocol: Suspend mode:<13 W; Off mode: 6 W
Full operation mode restored in less than 3 seconds.
DDC Capabilities Supports DDC-1, DDC-2b, DDC-2ab per VESA Display Data Channel Standard Version 2.1 and VESA Monitor Control Command Set Version 0.8p
Certifications UL, CSA, DHHS, TUV, FCC Class B, DOC class B, BZT, FDA CFR Subchapter J, ZH-1/61810.80, CPA, conforms to EPA standards
Television mode/Monitor mode An Additional DDC command that invokes high-gain and data modes. High-gain mode enhances brightness, contrast, width, height, and color temperature (6,500 K). Data mode is used for data work using a color temperature of 9,300 K, and lower brightness and contrast levels for better focus.