Specifications
      Show Part Numbers

Specifications - Destination 36-Inch Monitor
CRT Toshiba M90AHL50X01Invar shadow mask type
Diagonal CRT size is 38 in. with a viewable size of 35.5 in (viewable size must be quoted)
Neck size is 32.5 mm with a diagonal deflection angle of 110°
Maximum Resolution 800 × 600
Display Colors Unlimited
Horizontal Stripe Pitch Screen center: 0.9 mm
Screen edge: 1.1 mm

Note: The variance between the screen center and screen edge stripe pitch may make the monitor look comparatively fuzzy at the edge. This is not a defect.
Scanning Frequency Horizontal: 31 to 38 kHz
Vertical: 60 to 72 Hz
Aspect Ratio 4:3
Video Bandwidth 40 MHz nominal
Input Signal Video Sync Analog: 0.07 Vpp 75 Ohm
Separate sync: TTL level
Horizontal sync: positive/negative
Vertical sync: positive/negative
Power Input 90 to 264 VAC, 50 to 60 Hz ±3 Hz
Dimensions
(W × H × D)		 880 × 790 × 650 mm (Approximately 34.65 × 31.1 × 25.6 inches)
Weight 99 Kg (218 lbs)
Power Management Meets Energy Star requirements and conforms to the VESA Power Management protocol:
  • Suspend mode: <13 W
  • Off mode: 6 W
  • Full operation mode restored in less than 3 sec
DDC Capabilities Supports DDC-1, DDC-2b, DDC-2ab per VESA Display Data Channel Standard version 2.1 and VESA monitor control command set version 0.8 p
Certifications UL, CSA, DHHS, TUV, FCC Class B, DOC class B, BZT, FDA CFR Subchapter J, ZH-1/61810.80, CPA, conforms to EPA standards
Television Mode/Monitor Mode An Additional DDC command that invokes high-gain and data modes.
High-gain mode enhances brightness, contrast, width, height, and color temperature of 6,500° K.
Data mode is used for data work using a color temperature of 9,300° K and lower brightness and contrast levels for better focus