In the United States you can purchase an optional adjustable USB stand from the Gateway Web site. This stand can be adjusted for height, tilt, and screen rotation. With EzTune software installed on your computer, a sensor inside your monitor detects the rotation mode (portrait or landscape) your monitor is in, and rotates the screen accordingly.

Use the following steps to attach the adjustable stand.

1. Make sure that the monitor is turned off.

2. Place the monitor face down on a soft, non maring surface. A non-slip mat or a tablecloth is ideal. Let the monitor base hang down over the edge of the table.

3. Remove the two screws from the neck hinge, and then remove the neck from the LCD panel. Do not discard the screws.
   View Picture

4. Place the hinge cover (included with your adjustable stand) over the hinge. Attach the hinge cover, using the two screws you removed from the original neck hinge.

5. Remove the four small screws from the back of the LCD panel. Do not discard the four screws.
   View Picture

6. Slide the adjustable stand's neck on the base.
   View Picture

7. Using a flat screwdriver or your fingers, tighten the thumbscrew under the base to secure the neck in place.
   View Picture

8. With the stand facing you, press the mounting bracket lever to the left and hold it, and then remove the bracket from the stand.
   View Picture

9. Attach the bracket to the LCD panel, using the four screws you removed previously.
   View Picture

10. Slide the neck's bracket slot onto the bracket's mounting tab.
    View Picture

11. Press the bracket lever to the right and hold it, and then lower the neck into place. Release the lever.
    View Picture