The monitor can be raised or lowered 4.12 inches (105 mm).

The monitor can tilt 35 degrees.

The monitor can rotate 90 degrees. Note: To rotate the screen while the optional speaker bar is attached, first tilt the screen back for more clearance between the speaker and the tabletop.

Adjusting the Stand's Height Tension

The stand is factory adjusted to maintain the adjusted height for the monitor. However, you can manually adjust the monitor's tension.

1. Press the screwdriver access hole cap from below the base to remove it from the base.
   View Picture

2. Insert a Phillips screwdriver through the access hole in the base and onto the height tension screw (on the back of the stand).
   View Picture

3. Adjust the height tension screw so the monitor stays in place when you let go. If the monitor lowers by itself when you let go, turn the screw clockwise several complete turns. If the monitor rises when you let go, turn the screw counter-clockwise several complete turns. You may need to turn the screw several times before the tension is correct for the size of monitor.

4. Adjust the height tension screw so the raising and lowering forces are equal. After the forces are equalized, turn the tension screw clockwise two to four times to slightly decrease the lifting tension.

5. For optimal viewing, adjust the height so the top of the monitor is about one inch below eye level.

Adjusting the Stand's Tilt Tension

1. Adjust the tilt tension screw (located on top of the stand) so the monitor stays in place when you let go. If the monitor changes its tilt angle when you let go, turn the screw clockwise one complete turn to increase the tension.
   View Picture