Specifications
Part Number: 7001461Destination 36-inch Monitor Revision 2

Following are the specifications for the Destination 36-inch monitor, revision 2.
Specifications are subject to change without notice or obligation.

Feature Specification
CRT
  • 38 inches diagonal with a 35.5 inch viewable size
  • 32.5 millimeters (mm) neck size
  • 110 degree diagonal deflection angle
  • Mask Slotted shadow
    Maximum Resolution 800 × 600
    Display Colors Unlimited
    Horizontal Stripe Pitch
  • Screen center: 0.9 mm
  • Screen edge: 1.1 mm

    Note: The variance between screen center and screen edge stripe pitch may make the monitor look comparatively fuzzy at the edge. This is not a defect.

  • Scanning Frequency
  • Horizontal: 31 to 38 kilohertz (KHz)
  • Vertical: 60 to 72 hertz (Hz)
  • Aspect Ratio 4:3
    Video Bandwidth 40 megahertz (MHz) nominal
    Input Signal Video Synchronization
  • Analog: .07 Vp-p 75 Ohm
  • Separate sync: TTL level
  • Horizontal sync: Positive/negative
  • Vertical sync: Positive/negative
  • Power Input 90–264 volts alternating current (VAC), 50 or 60 Hz ± 3 Hz
    Dimensions (W × H × D) 880 × 790 × 650 mm (Approximately 34.65 × 31.1 × 25.6 inches)
    Weight 99 kilograms (kg) (218 pounds)
    Base Nondetachable
    Power Management Meets Energy Star requirements and conforms to the VESA Power Management Protocol
    • Suspend mode: <13 watts
    • Off mode: .6 watts
    • Full operation mode restored in less than 3 seconds.
    Display Data Channel (DDC) Capabilities Supports DDC-1, DDC-2b, DDC-2ab according to VESA DDC Standard 2.1 and VESA Monitor Control Command Set 0.8p.
    Television mode and monitor mode An additional DDC command that invokes high-gain and data modes.
    High-gain mode enhances brightness, contrast, width, height, and color temperature (6500 Kelvin).
    Data mode is used for data work using a color temperature of 9300 Kelvin. It also lowers brightness and contrast levels for better focus.
    Certifications UL, CSA, DHHS, TUV, FCC Class B, DOC Class B, BZT, FDA CFR Subchapter J, ZH-1/61810.80, CPA, conforms to EPA standards.