 |
|
Frequently Asked Questions
General
 Are drivers required for Serial ATA to work correctly?
What is the 4-pin jumper connector on the back of the Serial ATA hard drive used for?
Hard Drive
How do you know which Serial ATA hard drive is the primary or slave drive and which is bootable?
What version of GWSCAN supports Serial ATA hard drives?
RAID
Is RAID supported with Serial ATA in Windows 2000?
IS RAID level 1 supported on E-Series computers with Serial ATA?
Does the computer support using two Serial ATA hard drives without RAID configured?
Is the type of RAID used with Serial ATA Soft RAID?
Where is the RAID BIOS for the motherboard stored?
Is RAID configuration supported on IDE drives that are not Serial ATA?
During setup of RAID, a floppy disk drive is required. My computer does not have a floppy disk drive. What do I do?
If you completely set up the RAID configuration and software, and then go into the BIOS and disable Soft RAID Support, what happens?
What can I do when I get a SMART event on one array member of a RAID 1 volume with Serial ATA hard drives stating the volume is degraded?
|
|
|
United States
(change country or region)