OSD for RGB (PC) Video
      Show Part Numbers

This is the main menu screen for the on-screen display (OSD) when the video source is set to RGB (PC). The OSD is used to change a variety of settings for the Gateway® 18-inch LCD TV. The OSD is activated and navigated using either the TV's remote control or the TV's control panel buttons.

On-screen display menu

On the graphic, click the hyperlinks for more information.

 Refer to the table at the bottom of this page for information about activating, navigating, selecting, and adjusting options in the OSD.

  • Auto Adjust - When this option is selected, the settings for the video input source are automatically adjusted.
  • Contrast/Brightness - Use to adjust the contrast and brightness settings.
  • Color Adjust - Use to set the color to a preset mode. You can also customize the red, green, and blue levels separately.
  • Information - Displays the current horizontal (H) and vertical (V) fequencies, Pixel Clock, and Resolution settings.
  • Image Adjust - Use to adjust the H Position, V Position, Fine Tune, and Sharpness settings.
  • Input Select - Use to set the video input source.
  • Setup Menu - Use to adjust the OSD Position adn OSD Timeout settings.
  • PIP Menu - Use to turn PIP (picture-in-picture) off and on nad adjust the Source Select and H/V Position settings.
  • Memory Recall - When this option is selected, the picture settings are automatically reset to the factory default.

Action Using the Remote Control Using the TV Control Panel Buttons
Activate or close the OSD Press the MENU button Press the MENU button
Navigate to a menu item Press the up or down arrow buttons Press the CH up or down arrow buttons
Select a menu or an option within a menu Press the ENTER button Press the ENTER button
Adjust or change a selected option Press the left or right arrow buttons Press the VOL + or - buttons