Frequently Asked Questions
      Show Part Numbers

      Show Model(s)

Q: How do I remove and replace the power switch control panel on the 6-bay micro BTX case?

A: Remove the power switch control panel

  1. Turn off the computer, and then disconnect the power cord.

  2. Remove the right side panel.

  3. Remove the front bezel.

  4. The power switch control panel is located in the front, center of the case.
    View Picture

  5. Remove the air duct.

  6. Follow the power switch control panel cable into the case and to its connection on the motherboard. Note the location, and then disconnect the cable.
    View Picture

  7. Carefully pull the cable out through the front of the case
    View Picture

  8. At the front of the case, press the two top power switch control panel tabs toward each other, and then pull them out of the loop slots.
    View Picture

  9. Inside the case, press the two middle tabs toward each other, and then press them out the front of the case.
    View Picture

  10. Lift the power switch control panel off the case. If needed, wiggle the panel to loosen it from the case.

Replace the power switch control panel

  1. At the front of the case, insert the power switch control panel cable through the oval opening in the front of the case. This opening has smooth edges to prevent cable damage. Do not insert the cable through any other opening.
    View Picture
    View Picture

  2. Tilt the bottom tab of the power switch control panel into the opening on the case.

  3. Slide the panel down into position until the middle tabs align with the case slots.

  4. Press the middle tabs into the case slots until they engage.
    View Picture

  5. At the front of the case, press the power switch control panel top tabs toward each other, and then insert them into the loop slots on the case.
    View Picture

  6. Replace the air duct.

  7. Replace the front bezel.

  8. Replace the right side panel.

  9. Connect the power cord, and then turn on the computer.